Walk through the lane without presenting a card to test the anti-tailgating and intrusion alarms.
Place the cabinets over the pre-installed floor conduits. Ensure that the master and slave infrared sensor windows face each other exactly.
All electrical work must be performed by a licensed electrician and must comply with local electrical codes. Before starting, ensure the main power supply to the unit is disconnected.
[ MASTER CABINET ] [ SLAVE CABINET ] +------------------------------+ +------------------------------+ | [Main Power Input] | | | | 230V AC / 115V AC | | | | | | | | [Logic Controller] | | | | | | | | [Sync Port]------------------|------------|-[Sync Port] | | | Sync Cable | | | [Fire Alarm Terminal] | | [Motor Drive Connection] | | (Normally Closed - NC) | | | +------------------------------+ +------------------------------+ Mains Power Connection gunnebo speedstile fl installation manual
Before handing the installation over to the client, run through the standard startup sequence. Initial Power-Up
: Minimum concrete base dimensions are typically deep, depending on the cabinet length.
Power and communication cables should run at least 140mm below the finished floor level, rising a minimum of 50mm from the foundation at the point of entry into the cabinet. Anchor Fixing: Walk through the lane without presenting a card
You're looking for information on the Gunnebo SpeedStile FL installation manual. The Gunnebo SpeedStile is a popular brand of speed gates used for access control and security purposes. Here's some general information and guidelines related to its installation:
For detailed technical diagrams or specific programming codes, you can reference the full Installation Operation and Maintenance Manual (Siel Invest) or the SpeedStile FL Datasheet (Yumpu) .
The (Standard 600mm vs. Wide 900mm)
Frames must be leveled in both transverse and longitudinal directions using shims if necessary. Commissioning Steps
Fine-tune motor acceleration curves to match your site's security profile.
Install RFID, barcode, or biometric readers under the glass top lid or within the dedicated reader brackets. Step-by-Step Signal Termination: All electrical work must be performed by a
Use the base plate of the cabinet as a template to mark the floor anchoring points.
The floor must be able to support the weight of the cabinets. A concrete sub-floor with a minimum resistance of fckcube 30N/mm² is recommended. Conduit Running: