License Key Not Available Wincc Logging For Runtime Advanced ((top)) -

If you don't actually need historical data and want the message to stop, remove the features triggering it: Delete Logs: Historical data > Data logs Historical data > Alarm logs in the project tree and delete all entries. Disable GMP: Navigate to Runtime Settings > Good Manufacturing Practice and uncheck the "Good Manufacturing Practice" box. Recompile:

Perform a "Software (rebuild all)" on the HMI and download the project again. 3. Check for "Defective" Licenses

If you receive this error despite believing you are correctly licensed, check the following:

If the key status is flagged with a red cross, the physical files must be verified or repaired by Siemens Support:

You have two primary ways to resolve this error: if you need logging, or remove the logging configurations from your project if you do not. Option A: Install or Transfer the Required License license key not available wincc logging for runtime advanced

If you have installed the license but the error persists, check these three common technical blind spots: 1. The Automation License Manager Service is Stopped

On the (where Runtime Advanced runs):

If you encounter this error message, it is typically caused by one of the following root causes: 1. Missing Add-On License

This prevents data logging, archiving, and trend visualization in runtime, even though other WinCC Advanced features may work correctly. If you don't actually need historical data and

: If you are only simulating on an engineering PC, you can often ignore the message for testing, as functionality is typically not restricted in simulation .

Disclaimer: This guide is for informational purposes. Always refer to Siemens official documentation and licensing terms. Ensure your software is used in compliance with the license agreements.

: If you do not intend to use logging, check your project in TIA Portal for any configured tag logs or alarm logs and delete them to remove the requirement .

Do you actually for this specific station? The Automation License Manager Service is Stopped On

Click on the local drive (usually C: ) to view the table of installed license keys. Look for a license explicitly named "SIMATIC WinCC Logging for Runtime Advanced" .

Open . Inspect both the Historical Logs and Alarm Logs tabs.

If you’d like, I can walk you through how to properly install and activate the license in the Automation License Manager.

Plug the license USB drive into the runtime PC (or connect to it over a local network via ALM).