Switch Payload Injector Android ~upd~ Online

Ensure you are using a data-capable cable. Many cheap charging cables omit data sync wires entirely. Additionally, check if your Android phone requires you to manually enable "USB OTG" within its system settings.

The Nintendo Switch (specifically the Erista or "V1" unpatched models) contains a vulnerability in its bootrom. By shorting the right Joy-Con rail (Pin 10) to ground while holding the Volume Up button, you force the console into . In this state, the Switch is a blank slate waiting for instructions.

Switch the ends of the USB-C cable, or flip the plug upside down.

This only applies to "V1" unpatched Nintendo Switch models (Serial numbers beginning generally with XAW1 or XAJ1) or consoles with specific hardware modchips. Mariko (V2), Lite, and OLED models are patched at the hardware level against Fusée Gelée. switch payload injector android

Rekado also comes with standard payloads like Hekate and Fusee bundled in by default. 4. Putting the Switch into RCM NX Loader for Switch - Apps on Google Play

Slide the all the way down into the right Joy-Con rail. Hold down the Volume Up (+) button on the Switch. While holding Volume Up, press the Power button once.

A prompt will pop up on your Android screen asking for permission to allow the injector app to access the USB device. Tap or Allow . Step 4: Inject the Payload Ensure you are using a data-capable cable

The .bin files for the custom firmware bootstrap you want to run (such as hekate_ctcaer_x.x.x.bin or fusee.bin ). Step 1: Install a Payload Injector App on Android

Your console must be vulnerable to the fusee-gelee exploit (V1 unpatched models). Red-box (V2), Lite, and OLED models require a physical modchip and cannot use USB payload injection.

If you need help setting up the for your Switch? Share public link The Nintendo Switch (specifically the Erista or "V1"

When using the Switch Payload Injector, it's essential to take safety precautions to avoid damaging your device or compromising your data. Some safety precautions to consider include:

If your phone is USB-C and you use a standard USB-C to USB-C cable, ensure it supports data transfer.

Recommended for its graphical interface and utility suites.

You cannot use a standard USB-C to USB-C cable. The Switch is expecting a "host" negotiation. You need a , then plug a USB-A to USB-C cable into that, then into the Switch. Alternatively, buy a "USB-C OTG cable" specifically labeled for host mode.