Programat P95 Manual | Ivoclar

Proper installation is the first step toward successful firing.

If restorations come out over-fired (too glossy) or under-fired (matte, chipping), run a calibration test. The manual outlines using the "Calib" program with a ceramic calibration pellet. The target temperature difference should be less than 5°C. If higher, adjust the "Temp. Offset" parameter in the service menu (accessible with code 1234).

Furnace head position error; lift motor malfunction or mechanical obstruction.

Located at the rear, supplying power and controlled suction to the external vacuum pump. 2. Unpacking, Installation, and Initial Setup Ivoclar Programat P95 Manual

Insert the main power cable into a grounded wall outlet. Flip the primary power switch to the "ON" position. The display screen will initialize. Operating Controls and Interface Navigation

This foundational section outlines crucial safety warnings to protect both the operator and the equipment. It will cover specific requirements for the furnace's placement, such as maintaining distance from flammable materials, ensuring proper electrical supply, and connecting the vacuum pump. The manual will emphasize using the recommended , which is specifically coordinated with the furnace for optimal performance.

Press START and observe the wire through the viewing window. Proper installation is the first step toward successful

Consistent firing depends on regular upkeep. Physical and chemical residues in the chamber can cause "temperature shifts" over time. P95 Ifu PDF - Scribd

(Vacuum On): The temperature at which the vacuum pump activates. V2cap V sub 2 (Vacuum Off): The temperature at which the vacuum releases. Step-by-Step Firing Guide Follow this sequence for standard daily operations:

Once the cycle completes, the furnace will acoustic-signal and the lift will automatically descend. Use furnace tongs to carefully remove the firing tray and place it on a cooling rack. Maintenance and Calibration The target temperature difference should be less than 5°C

Before the first use, perform a calibration firing to ensure the temperature accuracy of the firing chamber. 3. Programming and Operating the Programat P95

The Ultimate Guide to the Ivoclar Programat P95 Dental Furnace